Advertisement
EN
CERAMIC FAN HEATER
INSTALLATION AND OPERATION INSTRUCTIONS
Read the instructions carefully before installing and operating the appliance or performing maintenance
operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or
damages. Store these instructions for future reference.
V 04/10
1
Advertisement
Table of Contents
Related Manuals for Argo SPLITTO JR
Summary of Contents for Argo SPLITTO JR
- Page 1 CERAMIC FAN HEATER INSTALLATION AND OPERATION INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference. V 04/10...
- Page 2 GENERAL SAFETY INFORMATION • Use this ceramic fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. • Ensure that the mains power complies with the voltage specified on the fan heater’s data plate (220-240VAC/50Hz).
- Page 3 • Do not attempt to repair, disassemble or modify the appliance. The appliance does not contain parts that can be repaired by the user. WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE PERFORMING MAINTENANCE OPERATIONS. • Do not place anything on the product; avoid placing wet garments on the fan heater. •...
- Page 4 INSTALLATION INSTRUCTIONS This fan heater is designed for wall-installation; it must be mounted 1.8 m above the floor and at least 25 cm from the wall on each side. Do not install on the floor. The fan heater must be installed on the wall before use. The installation sequence is listed below: 1.
- Page 5 PROTECTION SYSTEM The appliance includes a protection system against overheating that interrupts operation when certain components heat up excessively. To turn the fan heater off completely, push all buttons to OFF and remove the plug from the socket. WARNING: THE ON/OFF SWITCH IS NOT THE ONLY MEANS TO DISCONNECT THE POWER SUPPLY. WHEN THE APPLIANCE IS NOT USED OR IN THE EVENT OF MAINTENANCE OPERATIONS, ALWAYS PULL OUT THE PLUG FROM THE SOCKET.
Need help?
Do you have a question about the SPLITTO JR and is the answer not in the manual?
Questions and answers