Maintenance - Bellfires RDL3 R LF Installation Instructions & Manual For Maintenance

Gas fi res with closed combustion system
Table of Contents

Advertisement

Bellfi res
2

MAINTENANCE

2.1 ANNUAL MAINTENANCE
Maintenance consists of the following:
• Remove fi rst the embers, vermiculite granules, logs set or pebbles from the main
burner and carefully clean these with a soft brush.
• Clean and inspect (visually) the main burner, pilot light, combustion chamber,
fl ue system and combustion air intake. Dust can be removed using a vacuum
cleaner.
• Clean the glass on the inside of the appliance with glass spray or ceramic hob
cleaner. This also applies to the black mirror rear wall and side panels, if the
appliance is fi tted with these.
CAUTION !! :
If the appliance has anti-refl ective glass, please follow the
cleaning instructions in Chapter 4 of the "Operating Instructions
and Daily Maintenance Manual" booklet. Failure to follow these
instructions may result in damage to the anti-refl ective glass.
• After cleaning;
Carefully replace the embers, vermiculite granules, logs set or pebbles on and
around the main burner according to the installation directions in this instruction
booklet.
Do not place any embers, vermiculite granules, logs or pebbles against the
pilot light burner. Make sure that the pilot fl ame can burn at all times freely over
the main burner. Only in this way is proper ignition of the main burner ensured.
Ignoring these directions could lead to a dangerous situation.
• Check the gas supply, fl ue system, and combustion air supply route for leaks.
• Check the correct operation of the gas regulator block, thermocouple
circuit and the ignition of the main burner.
58
It is essential that the appliance, the complete
concentric fl ue system (where possible) and
the outlet are cleaned and inspected annually
by a recognised fi tter/gas specialist. The safe
operation of the appliance will thus remain
guaranteed.
English
Installation instructions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rdl3 r cfRdl3 l lfRdl3 l cfRdl3 lfRdl3 cf

Table of Contents