Table of Contents
Advertisement
If your machine has a second product button 5, you can,
by pressing button "
The product quantity to be set flashes first (prod:xxx):
6. With the "rinse button"
value. The quantity of water to be set flashes
(Wat: xxx):
7. Now switch the machine on again using the "On/Off"
switch 13. You now leave the setting mode.
8. Close the front door 8.
Note:
When the machine is warm, the warming-up block
can be bridged with the "-" button.
9. Check the beverages. If necessary, the setting
procedure must be repeated.
9 Care of the machine
9.1
Daily cleaning
Caution! Risk of scalding!
During cleaning hot water flows out of the beverage
outlet 6.
Caution! Risk of injury!
Only operate the machine with the beverage outlet
and the reservoir
switch the machine off with the "On/Off" switch 13.
Before starting up and after the end of operation, automatic
rinsing should be carried out.
1. Open the door lock
door
8
up.
2. Press the "rinse button" 10. Rinsing begins after the
front door
8
is closed.
38
", also change the setting values.
10
you reach the next setting
1
in place. Before dismantling,
12
(optional) and lift the front
Choc
Prod:
145
"+/-"change flashing value
Choc
Prod: 145
"+/-"change flashing value.
6
10
pot
Water: 160
pot
Water:
160
13
Advertisement
Table of Contents
