Specifications - Stihl FSA 85 Instruction Manual

Specifications

Battery
Type: Lithium-ion
Designation: AP, AR
The machine may be operated only with
original STIHL AP and AR rechargeable
batteries.
Power tool running time is dependent on
the energy content of the battery.
Cutting Attachment
Cutting swath:
FSA 65: 300 mm
FSA 85: 350 mm
Length
FSA 65: 1530 mm
FSA 85: 1650 mm
Weight
without battery, with cutting attachment
and deflector
FSA 65: 2.7 kg
FSA 85: 2.8 kg
Noise and Vibration Data
Noise and vibration data are determined
on the basis of the rated maximum
speed.
FSA 65, FSA 85
For further details on compliance with
Vibration Directive 2002/44/EC visit
www.stihl.com/vib.
Sound pressure level L to EN 50636-2-
p
91
FSA 65: 75 dB(A)
FSA 85: 77 dB(A)
Sound power level L to EN 50636-2-91
w
FSA 65: 89 dB(A)
FSA 85: 92 dB(A)
Vibration measurement a
hv
EN 50636-2-91
Handle, left Handle, right
2
FSA 65: 1.3 m/s 1.1 m/s
2
FSA 85: 1.4 m/s 0.8 m/s
The K-factor in accordance with
Directive 2006/42/EC is 2.5 dB(A) for
the sound pressure level and sound
power level; the K-factor in accordance
with Directive 2006/42/EC is 2.0 m/s
for the vibration measurement.
The vibration values quoted above have
been measured according to a
standardized test procedure and may be
used to compare electric power tools.
Depending on the type of usage, the
vibrations that actually occur may differ
from the values quoted.
The vibration values quoted may be
used for an initial assessment of the
user's exposure to vibrations.
The actual exposure to vibrations has to
be evaluated. This process may also
take into account times during which the
electric power tool is switched off and
times during which it is switched on but
running without load.
Transport
STIHL batteries fulfill the requirements
stated in UN-Manual
ST/SG/AC.10/11/Rev.5 Part III,
Subsection 38.3.
The user can transport STIHL batteries
by road transport to the place where the
machine is to be used without additional
requirements.
to
The lithium ion batteries included are
subject to the provisions of the
legislation relating to dangerous goods.
2
When shipped by a third party (e. g. air
2
transport or haulage firm), special
packaging and identification
requirements must be observed.
When preparing the item for shipment, a
dangerous goods expert must be
2
consulted. Please observe any further
national regulations.
Pack the battery so that it cannot move
inside the packaging.
Further transport instructions - see
www.stihl.com/safety-data-sheets
REACH
REACH is an EC regulation and stands
for the Registration, Evaluation,
Authorisation and Restriction of
Chemical substances.
For information on compliance with the
REACH regulation (EC) No. 1907/2006
see www.stihl.com/reach.
English
47