Stihl FSA 85 Instruction Manual page 33

Before Starting Work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
The trigger switch and trigger
–
lockout must move freely (retaining
latch to ‚) – switches must return to
the idle position when they are
released.
Use only an approved combination
–
of cutting attachment, deflector and
handle. All parts must be
assembled properly and securely.
To reduce the risk of injury, never
use metal cutting attachments.
Check that the cutting attachment is
–
properly and securely mounted and
in good condition.
Check protective devices (e.g.
–
deflector for cutting attachment) for
damage or wear. Always replace
damaged parts. Never operate the
unit with a damaged deflector.
Never attempt to modify the controls
–
or safety devices in any way.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Check contacts in battery
–
compartment for foreign matter.
Fit the battery correctly – it must
–
engage audibly.
Never use defective or deformed
–
batteries.
FSA 65, FSA 85
To reduce the risk of accidents, do not
operate your power tool if it is not
properly assembled and in good
condition.
Before switching on the power tool,
make sure the cutting attachment is not
touching the ground or any other object.
To reduce the risk of
injury, avoid contact with
the cutting attachment.
Note that the cutting
attachment continues to
run for a short period
after the power tool is
switched off – flywheel
effect.
Holding and Controlling the Power Tool
Always hold the power tool firmly with
both hands on the handles. Make sure
you always have good balance and
secure footing.
Right-handers
Left hand on the loop handle and right
hand on the control handle.
Left-handers
Right hand on the loop handle and left
hand on the control handle.
During Operation
In case of imminent danger or in an
emergency, switch off the motor
immediately, move retaining latch to ƒ
and remove the battery.
15m (50ft)
The cutting attachment may catch and
fling objects a great distance and cause
injury - therefore, do not allow any other
persons within a radius of 15 meters of
your own position. To reduce the risk of
damage to property, also maintain this
distance from other objects (vehicles,
windows). Even maintaining a distance
of 15 meters or more cannot exclude the
potential danger.
This power tool may be used in the rain
and wet. Dry off your power tool after
finishing work.
Do not leave the power tool outdoors in
the rain.
English
31