Instrument Cluster Indicator Lights - Dodge 2016 CHALLENGER User Manual

W H A T T O D O I N E M E R G E N C I E S
Vehicles Not Equipped With Keyless Enter-N-Go
1. Turn the ignition switch to the ON/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE:
• If the indicator message illuminates when you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this procedure.
• Resetting the oil life can also be done within the "Oil Life" menu under "Vehicle Info."

INSTRUMENT CLUSTER INDICATOR LIGHTS

– Turn Signal Indicator
The arrows will flash with the exterior turn signals when the turn signal lever is operated.
A tone will chime, and a DID message will appear if either turn signal is left on for more
than 1 mile (1.6 km).
NOTE:
If either indicator flashes at a rapid rate, check for a defective outside light bulb.
– Park/Headlight ON Indicator
This indicator will illuminate when the park lights or headlights are turned on.
– High Beam Indicator
Indicates that headlights are on high beam.
– Front Fog Light Indicator
This indicator will illuminate when the front fog lights are on.
– Vehicle Security Light
This light will flash rapidly for approximately 15 seconds when the vehicle security alarm
is arming. The light will flash at a slower speed continuously after the alarm is set. The
security light will also come on for about three seconds when the ignition is first turned on.
– Electronic Speed Control ON Indicator
This indicator will illuminate when the electronic speed control has been activated to the
"ON" position.
– Electronic Speed Control SET Indicator
This indicator will illuminate when the cruising speed has been set.
161