Instrument Cluster Indicator Lights - Dodge 2015 CHARGER User Manual

Hide thumbs Also See for 2015 CHARGER:
Table of Contents

Advertisement

W H A T T O D O I N E M E R G E N C I E S
Malfunction Indicator Light (MIL)
Certain conditions, such as a poor fuel quality, etc., may illuminate the MIL after engine
start. The vehicle should be serviced if the light stays on through several typical driving
cycles. In most situations, the vehicle will drive normally and not require towing.
If the MIL flashes when the engine is running, serious conditions may exist that could lead
to immediate loss of power or severe catalytic converter damage. We recommend you do
not operate the vehicle. Have the vehicle serviced immediately.
– Electronic Stability Control (ESC) OFF Indicator Light
The ESC Off mode is intended for off-highway or off-road use only and should not be used
on any public roadways. In this mode, all TCS and ESC stability features are turned OFF.
To enter the "Full Off" mode, press and hold the "ESC" switch for five seconds while the
vehicle is stopped with the engine running. After five seconds, a chime will sound, the
"ESC OFF" Indicator Light" will illuminate, and the "ESC OFF" message will display in the
vehicle cluster (left of the odometer). The "ESC OFF" message may appear in the Driver
Information Display (DID). To turn ESC ON again, momentarily press the "ESC" switch.

INSTRUMENT CLUSTER INDICATOR LIGHTS

– Turn Signal Indicator
The arrows will flash with the exterior turn signals when the turn signal lever is operated.
A tone will chime, and a DID message will appear if either turn signal is left on for more
than 1 mile (1.6 km).
NOTE:
If either indicator flashes at a rapid rate, check for a defective outside light bulb.
– High Beam Indicator
Indicates that headlights are on high beam.
– Front Fog Light Indicator
This indicator will illuminate when the front fog lights are on.
– Vehicle Security Light
This light will flash rapidly for approximately 15 seconds when the vehicle security alarm
is arming. The light will flash at a slower speed continuously after the alarm is set. The
security light will also come on for about three seconds when the ignition is first turned on.
Electronic Speed Control Set
Indicates that the Electronic Speed Control has been set.
165

Advertisement

Table of Contents
loading

Table of Contents