Registering A Unit - Panasonic KX-TG7341NZ Operating Instructions Manual

Programming
Selecting area codes to be
deleted automatically
In some situations, phone numbers
stored automatically in the caller list
(page 29) will include area codes. If you
do not want to dial the area codes when
making calls from the caller list, you can
store the area codes which you want the
unit to delete automatically.
Example: You have stored the area
code "09". If you make a call from the
caller list to the phone number "09-456-
7890", the unit dials "456-7890".
1
K (middle soft key)
2
{V}/{^}: "Base Unit Setup" i
M
3
{V}/{^}: "Area Code" i M
4
Enter an area code (5 digits max.).
i M i {ih}
Note:
L The use of this feature can prevent a
National Call from being dialled. E.g.,
in the case of the South Island, the
"03" will be omitted and will therefore
prevent a National Call to other areas
of the South Island.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, contact your nearest
Panasonic service centre.
1
K (middle soft key)
2
{V}/{^}: "Base Unit Setup" i
M
3
{V}/{^}: "Base Unit PIN" i
M
26
4
Enter the current 4-digit base unit
PIN (default: "0000").
5
Enter the new 4-digit base unit PIN.
i M i {ih}

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to
the base unit.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), re-
register the handset.
1
Handset:
K (middle soft key)
2
{V}/{^}: "Handset Setup" i
M
3
{V}/{^}: "Register H.set" i
M
4
Base unit:
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.