Race-Start Timers - Raymarine ST60+ SPEED INSTRUMENT Owner's Handbook Manual

Chapter 1: Operation

Race-start timers

You can set each race-start timer to any whole-minute value from 1 to 15 minutes.
When the instrument is first installed, the race-start timers are set to 4 and 5 min-
Note:
utes respectively.
To set a race-start timer:
1. Use the timer button as shown in the
the required race-start timer.
2. Simultaneously press the timer and reset buttons to enter the race-start
timer set mode.
3. Use either the timer or reset button to set the required value.
4. Simultaneously press the timer and reset buttons to save the value and
leave the race-start timer adjust mode.
Set race-start timer
Timer buzzer
The timer buzzer is enabled or disabled during User calibration procedure (see
Chapter 4, Calibration
race-start timers, the buzzer will:
• Double-beep every minute.
• Beep three times at the start of the last 30 seconds.
• Beep once for each of the last 10 seconds.
• Beep for 2 seconds at zero.
After a race-start timer has counted-down to zero, it will then start counting up.
Note:
reset
screen
+
timer
reset
+
timer
). If the timer buzzer is enabled and you are using one of the
Selecting timer
flow diagram, to select
Increase time
Set
Decrease time
5
reset
OR
timer