Variation Setting - Raymarine ST60 Compass Instrument Owner's Handbook Manual

Chapter 4: Calibration
Linearisation
CAL
TRUE
disp
CAL
Heading
alignment
TRUE
User Calibration

Variation setting

A positive value indicates easterly and a negative value westerly. If the variation
has not been set, or the data is not available, the digital display shows a series of
dashes.
Changes to variation must be accepted before a TRUE heading can be selected,
True/magnetic selection
(see
If the ST60 Compass instrument is connected to SeaTalk and a value for variation
is present on SeaTalk (e.g. from an autopilot), this is accepted as the value for the
instrument. If a value is not present on SeaTalk, or if the instrument is not
connected to SeaTalk, use the < and > keys to set the appropriate value.
Hold down
disp
Calibration
Entry Screen
disp
TRUE
MAG
Press either
to set the required values
MAG
Lock Mode
disp
CAL
TRUE
below
and lock for approximately 2 seconds
disp
MAG
or
disp
MAG
)
.
True/Magnetic
Selection
CAL
TRUE
MAG
disp
Variation
Setting
CAL
TRUE MAG
29
D4391-1