Table of Contents
Advertisement
Chapter 2 Preparations
Using the optional RAID controller
For details, refer to the manual that comes with optional RAID controller.
1.10.4
Removal
To remove a riser card, reverse the installation procedure. Hold the riser card to which the PCI card is
attached firmly and remove it. Additionally, another worker must hold this server to prevent it from moving
when removing the riser card.
If using the server while the PCI card is removed, attach the blank cover that comes with the riser card.
Important
• Avoid static electricity to work with the procedure below. For details, see
Chapter 2 (1.2 Overview of Installation and Removal).
• Do not change the mode to hibernate when building a RAID system.
Note
• When installing an optional RAID controller, run the BIOS Setup Utility, select
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM ( xx is PCI slot number) is set to Enabled .
• When connecting a RAID controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup Utility. If the setting is 9th or lower, the
configuration menu for RAID controllers cannot be launched.
Express5800/R110h-1 User's Guide
1. Installing Internal Optional Devices
73
Advertisement
Table of Contents
