Table of Contents
Advertisement
Chapter 2 Preparations
(c)
Installation
For the instruction of installing the optional RAID controller, see Chapter 2 (1.10 PCI Card).
Removal
To remove the optional RAID controller, reverse the installation procedure.
If you intend to use with the card removed, be sure to attach the blank cover attached to the riser card.
50
Important
• To avoid static electricity, see Chapter 1 (1.8 Anti-static Measures) in Safety
Precautions and Regulatory Notices.
• Do not change the mode to hibernate when building a RAID System.
• To install the SAS hard disk drive together with SATA hard disk drive, there
are some conditions to be met. See Chapter 2 (1.8.2 Notes on setting up a
RAID System).
Tips
When using SAS hard disk drives, install a RAID controller to the server.
Note
• When installing an optional RAID Controller, start the BIOS Setup utility, select
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
• When connecting a RAID controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID controllers cannot be launched.
Express5800/R110h-1 User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
