Table of Contents
Advertisement
Chapter 2 Preparations
7.
Fix the PCI card with the screw you removed in step 5.
8.
Connect the riser card to the mother
board slot and fix the card with the screw
you removed in step 3.
When connecting the card, position the
terminal part of the card to the slot on the
motherboard and insert it.
9.
Reassemble the server.
10.
Turn on the server and make sure that no error messages are displayed on POST screen.
For details on POST error messages, see Chapter 3 (1. POST Error Message) in "Maintenance Guide".
11.
To set up the PCI card, run the configuration utility on the installed the card, if necessary. For details,
refer to the manual that comes with the card.
If a RAID controller, SAS controller or LAN card which connects to any bootable device is added, the
boot priority is changed to the default settings. Configure the boot priority in the Boot menu of the BIOS
Setup Utility. For details, see Chapter 2 (1.2.5 Boot) in "Maintenance Guide".
72
Important
Do not touch the terminal part of riser cards or PCI cards and the signal pins
of electric parts installed on the card. Installing cards with dirt or oil can
cause malfunction.
Tips
If you have trouble installing the card, remove the card once and try again. If you
apply excessive pressure on the card, a PCI card or riser card might break.
Note
• Make sure that the head of a PCI card bracket is seated into the fixed slot.
• Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.
PCI 1C slot
Tips
If the cable which is to be connected to the connector on the motherboard of the
server is provided on the board, connect it to the board before installing the riser
card to the server.
Express5800/R110h-1 User's Guide
1. Installing Internal Optional Devices
PCI 1B slot
Advertisement
Table of Contents
