Panasonic CU-E18DBE Service Manual page 56

CS-E15DD3EW CU-E15DBE / CS-E18DD3EW CU-E18DBE
PREPARING TO INSTALL THE INDOOR UNIT
• Fit the drain hose insulation 7 around the drain hose as shown in the diagram beside.
• Attach the discharge chamber. (
• Cut out the intake cut-out portions at the unit rear panel using a cutter or other tools to make openings.
• Remove the two screws at the rear edge of the unit top panel and attach the intake chamber. (
Securing the Hanging Bolts
Switching the High State Switch (SW2)
• To increase the air volume, open the control box and on the control board, switch the high state switch (SW2) to "HI".
• See the diagram for "Connecting the Indoor/Outdoor Connecting Cable".
Installation into the Ceiling
• Attach the nuts and washers to the hanging bolts, then lift up and hook the main unit onto the hanging fixtures.
• Check if the unit is leveled using a level or a vinyl hose filled partially with water.
) (10 screws)
56
) (8 screws)