Panasonic KX-TCD715ALM Operating Instructions Manual page 76

Before Requesting Help
Problem
The paged handset does not answer.
While using the intercom, two tones
sound.
The unit misdials when connected to a
PBX.
You cannot register the handset in the
base unit.
The battery strength is not displayed
correctly.
" " flashes or the unit beeps every
15 seconds.
You charged the batteries fully, but
" " flashes.
For Customers
Panasonic Australia operates a toll free Customer Care Centre.
Please phone Panasonic on 132600 for assistance.
76
Remedy
The handset is not in the same radio area.
The handset is engaged in an outside call.
The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p. 59).
A call is being received. To answer, press
or and
Check the pause function (p. 43).
The base unit has registered a maximum of 6
handsets or the handset has registered a maximum
of 4 base units.
A wrong base unit PIN was entered. Enter the
correct PIN.
There is interference from other electrical units.
Locate the handset and base unit away from them.
You must finish registration within 1 minute after the
ringer tone sounds, or programming will be cancelled
(p. 59).
Check that the battery type selection is correct
(p. 70).
Charge the batteries fully (p. 12).
Clean the charge contacts and charge again (p. 13).
Install new batteries (p. 70).
and
.