General Safety - Zanussi ZWT 71401 WA User Manual

General Safety

Do not change the specification of this appliance.
•
The appliance can be installed as freestanding or below the
•
kitchen counter with correct space.
Do not install the appliance behind a lockable door, a sliding
•
door or a door with a hinge on the opposite side, where the
appliance door can not be fully opened.
Connect the mains plug to the mains socket only at the end of
•
the installation. Make sure that there is access to the mains
plug after the installation.
The ventilation openings in the base (if applicable) must not be
•
obstructed by a carpet.
Ensure you have good ventilation in the installation room to
•
avoid the back flow of gases into the room from appliances
burning other fuels, including open fires.
Exhaust air must not be discharged into a flue which is used for
•
exhausting fumes from appliances burning gas or other fuels (if
applicable).
The operating water pressure (minimum and maximum) must be
•
between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa).
Obey the maximum load volume of 7 kg (refer to the
•
"Programme chart" chapter).
The appliance is to be connected to the water mains using the
•
new supplied hose-sets. Old hose sets must not be reused.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
Wipe away lint that has accumulated around the appliance.
•
Items that have been soiled with substances such as cooking
•
oil, acetone, alcohol, petrol, kerosene, spot removers,
turpentine, waxes and wax removers should be washed in hot
water with an extra amount of detergent before being dried in
the wash dryer.
Do not use the appliance if industrial chemicals have been used
•
for cleaning.
Do not dry unwashed items in the wash dryer.
•
www.zanussi.com 3