Zanussi ZWT 71401 WA User Manual page 22

2
1
22
• After removing all the
packaging, carefully
lay the appliance on
it's back to remove
the polystyrene base
from the bottom.
• Remove the power
supply cable and the
draining hose from
the hose holders on
the rear of the
appliance.
• Unscrew the three
bolts.
• Slide out the relevant
plastic spacers.
• Remove the
polystyrene block
fitted on the door
seal. Pull out all items
from the drum.
• Fill the smaller upper
hole and the two
large ones with the
plastic plug caps
supplied in the bag
with the User Manual.
Positionning
• Install the machine on a flat hard floor. Make
sure that air circulation around the appliance
is not impeded by carpets, rugs etc.
• Check that the machine does not touch the
wall or other kitchen units.
• If necessary, check the setting with a spirit
level. Any necessary adjustment can be made
with a spanner.
Never place cardboard, wood or
similar materials under the appliance
to compensate for any unevenness
in the floor.
Water inlet
• The inlet hose is supplied with the appliance
and can been found inside the appliance
drum.
• Do not use the hose from your previous
appliance to connect to the water supply.
This appliance must be connected
toa cold water supply.
45˚
35˚
• Level the appliance
by raising or lowering
the feet.
• The feet may be tight
to adjust as they
incorporate a self
locking nut, but the
appliance MUST be
level and stable.
• After having levelled
the appliance, tighten
the lock nuts.
• Accurate levelling
prevents vibration,
noise and
displacement of the
appliance during
operation.
• Connect the hose
with the angled
connection to the
machine. Do not
place the inlet hose
downwards.
• Angle the hose to the
left or right depending
on the position of
your water tap.
www.zanussi.com