Building In - Zanussi ZWT 71401 WA User Manual

• Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks.
• The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:

Building in

Overview
This appliance has been designed to be built
into the kitchen furniture. The recess should
have the dimensions shown in the picture
below:
www.zanussi.com
• Connect the hose to
a tap with a
3/4"thread. Always
use the hose supplied
with the appliance.
• Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
In this case, make sure the end cannot come
unhooked when the appliance is emptying.
This could be done by tying it to the tap with
a piece of string or attaching it to the wall.
• In a sink drain pipe branch.
This branch must be above the trap so that
the bend is at least 60 cm above the ground.
• Directly into a drain pipe at a height of
not less than 60 cm and not more than 90
cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drainpipe must be larger than the outside
diameter of the drain hose. The drain hose
must not be kinked.
The drain hose may be extended to a maximum
of 4 metres. An additional drain hose and
joining piece is available from your local Service
Centre
23