Zanussi ZWT 71401 WA User Manual page 20

• - The appliance door is open or not
closed correctly. Please check the door!
• - The mains supply is unstable. Wait
until the mains supply is stable.
Possible failures
Problem
The programme does not
start.
The appliance does not fill
with water properly.
The appliance does not
drain the water.
The spin phase does not
operate or the washing cy-
cle lasts longer than usual-
ly.
There is water on the floor.
You cannot open the appli-
ance door.
20
• Make sure that the mains plug is connected to the mains socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse box.
• Make sure that the Start/Pause has been pressed.
• If the delay start is set, cancel the setting or wait for the end of
countdown.
• Deactivate the Child Lock function if it is on (if available).
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter of the inlet hose and the filter of the valve
are not clogged. Refer to "Care and cleaning".
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the connection of the water inlet hose is correct.
• Make sure that the drain hose is in the correct position. The hose
may be too low.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Make sure that the drain filter is not clogged. Clean the filter, if nec-
essary. Refer to 'Care and cleaning'.
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set a programme without drain
phase.
• Set the drain programme if you set an option which ends with wa-
ter in the tub.
• Set the spin programme.
• Make sure that the drain filter is not clogged. Clean the filter, if nec-
essary. Refer to 'Care and cleaning'.
• Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
• Make sure that the couplings of the water hoses are tight and there
is not water leakages.
• Make sure that the drain hose have no damages.
• Make sure you use the correct detergent and the correct quantity
of it.
• Make sure you have replaced the emergency emptying cap into the
filter
• Make sure you have properly screwed the filter in after cleaning.
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the drum.
WARNING!
Deactivate the appliance before you
do the checks.
Possible solution
www.zanussi.com