Audio Input Select - Panasonic TH-55SQ1W Operating Instructions Manual

Hide thumbs Also See for TH-55SQ1W:

Table of Contents

■

[PC power management] (DPMS function)

When this function is set to [On], it operates under

the following conditions to turn the power on or off

automatically.

When no pictures (HD/VD sync signals) are

detected for 60 seconds or so at PC input:

Power is turned off (standby); the power indicator

lights up orange.

When pictures (HD/VD sync signals) are

subsequently detected at PC input:

Power is turned on; the power indicator lights up

green.

Note

●

This function is effective when [Sync] in [Signal] is set

to [Auto] or [HV sync] and [Component/RGB-in select]

are set to [RGB]. (see page 60)

●

This function may not operate depending on the video

output devices.

■

[Power save]

This function adjusts the brightness of the backlight to

reduce power consumption.

[Off]:

The power save function does not operate.

[On]:

Backlight brightness is reduced.

■

[Extended standby mode]

Sets the operation in standby mode by the "Power

management" function for the input terminal for which

the "Power management" function is set to [On].

[Off]:

If a video signal (synchronized signal) is detected

at the input terminal with which the standby mode

is entered, the power is turned "ON" with the input.

[On]:

If a video signal (synchronized signal) is detected

at any of the input terminals for which the "Power

management" function is set to [On], the power

is turned "ON", and the input is switched to the

detected input.

Note

●

When [Input search] is [All inputs] or [Custom], the

[Input search] function is prioritised. (The "Power

management" function does not operate for each

terminal.) (For details of [Input search] function, see

page 63.)

●

When [Failover/Failback] - [Input change mode] is

set to items other than [Off], the [Failover/Failback]

function is prioritised. (The "Power management"

function does not operate for each terminal.) (For

details of [Failover/Failback] function, see page 65.)

■

[Changing delay]

Sets the delay time until the input is switched when

[Power management mode] is [Input detection].

[Off]:

Switches the input if a signal is interrupted even for

a very short period.

1 to 10:

Sets the delay time (sec.). Switches the input when

the set time has elapsed after detecting no signal

is present. However, if the detection period during

which no signal is present is shorter than the set

delay time, the input is not switched.

Note

●

The operation when [Input detection] is selected is the

same as the operation when [Input search] is set to

[Input detection]. (see page 64)