Audio Input Select; Hdmi-Cec Settings - Panasonic TH-75EQ1W Operating Instructions Manual

[Changing delay]
Sets the delay time until the input is switched when
[Power management mode] is [Input detection].
[Off]:
Switches the input if a signal is interrupted even for
a very short period.
1 to 10:
Sets the delay time (sec.). Switches the input when
the set time has elapsed after detecting no signal
is present. However, if the detection period during
which no signal is present is shorter than the set
delay time, the input is not switched.
Note
●
The operation when [Input detection] is selected is the
same as the operation when [Input search] is set to
[Input detection]. (see page 52)

Audio input select

[Audio input select] - submenu screen
Audio input select
HDMI1 HDMI1
HDMI2 HDMI2
AUDIO IN
DVI-D
AUDIO IN
PC
VIDEO
● The illustration above shows the factory settings.
Video input
HDMI1
HDMI2
DVI-D / PC* /
VIDEO
●
No audio: No audio input (Mute)
*: [PC] may be displayed as [PC[YP
the settings of [PC input mode]. (see page 75)
When the setting for the audio input has been
changed from the factory settings, the audio input is
displayed as below.
HDMI1
Full
AV IN
AV IN
Audio input
HDMI1 / AV IN / AUDIO IN /
No audio
HDMI2 / AV IN / AUDIO IN /
No audio
AV IN / AUDIO IN / No audio
P ]] depending on
B R

HDMI-CEC settings

Set for HDMI-CEC function.
For details of HDMI-CEC function, refer to "Using HDMI-
CEC function". (see page 109)
[HDMI-CEC settings] - submenu screen
HDMI-CEC settings
HDMI-CEC control
HDMI1 ----
HDMI2 ----
HDMI-CEC operation
MENU code
Link function
Display → Device Disable
Device → Display Disable
■
[HDMI-CEC control]
Enables/Disables the HDMI-CEC function.
[Disable]: Disables HDMI-CEC control.
[Enable]: Enables HDMI-CEC control.
Note
● Set to [Enable] to operate HDMI-CEC compatible
device with remote control of the unit.
■
[HDMI1]
Displays the device to operate when HDMI-CEC
compatible device is connected to HDMI 1 terminal.
The control subject can be changed with
Note
●
When there is no connected device, [----] will be
displayed.
■
[HDMI2]
Displays the device to operate when HDMI-CEC
compatible device is connected to HDMI 2 terminal.
The control subject can be changed with
Note
●
When there is no connected device, [----] will be
displayed.
■
[HDMI-CEC operation]
Displays the operation screen of the HDMI-CEC
compatible device.
Press <RETURN> to hide the operation screen.
■
[MENU code]
Changes the code to assign for the [MENU] operation
on the HDMI-CEC operation screen.
Adjust the code to that of the connected HDMI-CEC
compatible device.
Enable
1
.
.
English
59