Specifications - Sony PVM-X300 Operating Instructions Manual

Specifications

Picture performance
LCD panel a-Si TFT Active Matrix
Picture size (diagonal)
767.5 mm (30.2 inches)
Effective picture size (H × V)
678.9 × 358.0 mm
3
(26 /
Resolution (H × V)
4096 × 2160 pixels
Aspect 17:9
Pixel efficiency 99.99%
Panel drive RGB 10-bit
Viewing angle (Panel specification)
89º/89º/89º/89º (typical)
(up/down/left/right, contrast > 10:1)
Color temperature
D65, D93
Warm-up time Approx. 30 minutes
To provide stable picture quality, turn
on the power of the monitor and
leave it in this state for more than 30
minutes.
Audio
SDI audio format
48 kHz (Video Sync), Incompressible
L-PCM, 24-bit
HDMI audio format
32 kHz/44.1 kHz/48 kHz,
Incompressible L-PCM, 24-bit
Input
SDI input connector
BNC type (4)
HDMI input connector
HDMI (4)
HDCP correspondence
Output
SDI monitor output connector
BNC type (4)
Output signal amplitude: 800 mVp-p
±10%
Output impedance: 75 Ω unbalanced
Audio monitor output connector
Stereo mini jack (1)
Built-in speaker output
1.0 W Stereo
Headphones output connector
Stereo mini jack (1)
24
Specifications
1
× 14 / inches)
4 8
General
Power AC 100 to 240 V, 2.4 A to 1.2 A, 50/
60 Hz
Power consumption
Approx. 200 W (max. without
mounting the option)
Approx. 230 W (max. with the option
mounted)
Inrush current
(1) Maximum possible inrush current
at initial switch-on (Voltage
changes caused by manual
switching):
50 A peak, 3 A r.m.s. (240V AC)
(2) Inrush current after a mains
interruption of five seconds
(Voltage changes caused at zero-
crossing):
15 A peak, 3 A r.m.s. (240V AC)
Operating conditions
Temperature
0 °C to 35 °C (32 °F to 95 °F)
Recommended temperature
20 °C to 30 °C (68 °F to 86 °F)
Humidity 30% to 85% (no condensation)
Pressure 700 hPa to 1060 hPa
Storage and transport conditions
Temperature
–20 °C to +60 °C (–4 °F to +140 °F)
Humidity 0% to 90%
Pressure 700 hPa to 1060 hPa
Accessories supplied
AC power cord (1)
AC plug holder (1)
Before Using This Unit (1)
CD-ROM (1)
Optional accessory
BKM-XP1 4K SxS Player
Design and specifications are subject to change without
notice.