Sony PVM-X300 Operating Instructions Manual page 19

MARKER SETTING
USER CONFIG-MARKER SETTING
xx
MARKER:
xxxx
ASPECT MARKER:
xx
CENTER MARKER:
xx
AREA MARKER:
xxx
BRIGHTNESS:
xxx
ASPECT MAT:
Submenu Setting
MARKER Selects ON to display the marker and
OFF not to display.
ASPECT MARKER Selects the aspect ratio of the aspect
marker.
You can select from among OFF, 4:3,
16:9, 15:9, 14:9, 13:9, 1.85:1 and 2.35:1.
CENTER Selects ON to display the center marker
MARKER and OFF not to display.
AREA MARKER Selects the size of the area marker.
You can select from among OFF, 80%,
85%, 88%, 90% and 93%.
BRIGHTNESS Sets the luminance of the line of the
marker.
• LOW: dark
• HIGH: bright
ASPECT MAT Sets whether or not to set the blanking
outside the area of the aspect marker.
• OFF: Blanking is released.
• HALF: The portion of the image
outside the aspect marker area is
semimasked.
• BLACK: The portion of the image
outside the aspect marker area is
hidden.
FOCUS ASSIST SETTING
USER CONFIG-FOCUS ASSIST SETTING
xx
FOCUS ASSIST:
xxxxx
FOCUS MODE:
xxx
COLOR:
xxxxxxx
FREQUENCY:
xxxx
RANGE:
xx
GAIN:
Submenu Setting
FOCUS ASSIST Enables or disables the focus assist
function that can highlight focused
objects with contrasting color.
• OFF: to disable the focus assist
function
• ON: to enable the focus assist function
Submenu Setting
FOCUS MODE Switches the focus mode.
• STD: An image with sharpened edges
is displayed.
• COLOR: Displays the intensified
areas of images with color
selected in COLOR below.
COLOR Selects the color to intensify from
among RED, GREEN, BLUE,
YELLOW and WHITE.
FREQUENCY Sets the center frequency of the edge
sharpening signal.
You can select LOW, MIDDLE,
MIDDLE HIGH, or HIGH.
RANGE Sets the target area for edge sharpening.
You can select NARROW, MIDDLE, or
WIDE.
GAIN Sets the level of edge sharpening.
You can select from 0 to 100.
TIME CODE SETTING
USER CONFIG-TIME CODE SETTING
xx
TIME CODE:
xxxx
FORMAT:
xxxxxx
POSITION:
xxx
BRIGHTNESS:
xxx
MAT:
Submenu Setting
TIME CODE Selects ON to display the time code
display and OFF not to display.
FORMAT Selects the type of the time code to be
displayed.
• VITC: to display the VITC time code
• LTC: to display the LTC time code
POSITION* Sets the position of the time code display
on the screen.
• TOP LEFT: to display at the top left
• TOP RIGHT: to display at the top
right
• BOTTOM LEFT: to display at the
bottom left
• BOTTOM RIGHT: to display at the
bottom right
BRIGHTNESS Sets the luminance of the time code
display.
• LOW: dark
• HIGH: bright
MAT Selects the background of the time code
display.
• BLACK: The background becomes
black. The image is hidden
behind the background.
• HALF: The background becomes
transparent. The image is seen
through under the time code
display.
19
Adjustment Using the Menus