Installing An Option Card - IBM infoprint 1764 User Manual

7
Press the ribbon cable connector into the connector on the system board.
8
Flip the hard disk over, and then press the three posts on the mounting plate into the holes on the system board.
The hard disk snaps into place.

Installing an option card

Your printer has one expansion card slot that supports a number of option cards. The following table describes their
function.
Card
MarkNet internal print server
Parallel 1284-B Interface Card
Serial Interface Card
You need a small Phillips screwdriver to install these options.
1
Remove the system board access cover. For more information, see Removing the system board access cover.
2
Remove the screw from the metal plate that covers the connector slot, and then lift the plate off.
Save the screw.
Warning: Option cards are easily damaged by static electricity. Touch something metal on the printer before you
touch an option card.
3
Unpack the option card.
Save the packing materials.
4
Align the connector on the option card with the connector on the system board.
The cable connectors on the side of the option card must fit through the connector slot.
5
Push the option card firmly into the option card connector.
6
Secure the card to the system board with the screw.
Installing and removing options
Function
Adds an Ethernet or Token-Ring port so you can connect your printer to a network
Adds a parallel port
Adds a serial port
Installing memory and option cards
16