Black & Decker BDEBCS14 Instruction Manual page 7

vISe OPeRATION (fIg. g)
The vise (4) has a quick-travel feature. To release
the vise when it is clamped tightly, turn the crank (6)
counterclockwise one or two times to remove clamping
pressure. Lift vise lever (7) up. Pull crank assembly out
as far as desired. Vise may be pushed forward into work
without cranking. Lower vise lever then tighten vise on
work by using crank.
feNCe OPeRATION (fIg. h, I)
CAUTION:
To reduce the risk of injury,
turn unit off and disconnect machine from
power source before installing and removing
accessories, before adjusting or changing
set-ups or when making repairs. Be sure the
trigger switch is in the Off position. An
accidental start-up can cause injury.
The fence (3) can be adjusted two ways: to change
desired cutting angle and to change spacing between
the fence and vise.
TO ChANge The DeSIReD CUTTINg ANgLe
Use the wrench (5) provided to loosen (do not remove)
the two fence bolts (3a). Align the desired angle
indicator line with the slot line (3b) in the base (2).
Securely tighten both fence bolts before use. For more
accurate square cuts, disconnect the power supply,
loosen the two fence bolts, push arm down until wheel extends into base. Place a
square against the wheel and adjust fence against the square. Securely tighten both
fence bolts before use. When making a miter cut, the vise (4) may not clamp securely,
depending on the thickness of the workpiece and the miter angle. Other aids (such as
spring, bar or C-clamps) will be necessary to secure the workpiece to the fence when
making these cuts.
TO ChANge SPACINg BeTWeeN The feNCe AND vISe
Using the wrench provided, loosen and remove the two fence bolts (3a). Adjust the fence
(3) to desired locations. Insert both fence bolts in provided locations. Securely tighten both
fence bolts before use.
ReMOvAL AND INSTALLATION Of WheeLS (fIg. J, K)
CAUTION:
Turn off and unplug the tool before
making any adjustments or removing or installing
attachments or accessories. Be sure the trigger
switch is in the Off position. Do not make any
adjustment while the wheel is in motion.
Do not make any adjustment while chop saw is plugged
into power supply.
1. Push in spindle lock (10) and rotate wheel (8) by hand
until wheel lock lever engages slot in inside flange (15)
to lock wheel. Loosen the bolt (16) counterclockwise
in the center of the abrasive wheel with the included
wrench (5). Bolt has right-hand thread.
2. Remove the bolt (16), washer (17), outside flange (18)
and old wheel (8).
3. Make sure flange surfaces are clean and flat. Install
the new abrasive wheel by reversing the above steps.
4. Do not overtighten bolt.
WARNINg:
Risk of personal injury. Check the work
surface that the chop saw rests on when replacing with a
new abrasive wheel. It is possible that the wheel may contact ANY ITEMS OR
STRUCTURE THAT EXTENDS ABOVE work surface (under the base) when the arm is
fully lowered.
g
h
3
I
3b
J
K
7
4
2
3a
10
8
15 18
7
6
4
17
16