Slacken adjusting screws 3 on
left and right by turning them
counter-clockwise.
Remove quick-release axle 4,
supporting the rear wheel in
the process (for example slip a
wooden block of suitable thick-
ness underneath the wheel).
Push the rear wheel as far
forward as possible and
disengage the chain from
sprocket 5.
Roll the rear wheel back until
it is clear of the swinging arm,
while holding the brake caliper
on the left-hand side.
The sprocket and the
spacer sleeves on left
and right are loose fits in the
wheel. Make sure that these
parts are not damaged or lost on
removal.
Installing rear wheel
Make sure that the brake cal-
iper moves on guide 6.
Roll the rear wheel into the
swinging arm, making sure that
the brake disc passes between
the brake pads.
8
79
z