IBM x3200 4362 User Manual page 54

10. Connect one end of the power cord into the connector on the back of the
11. Make sure that both the ac and dc power LEDs on the rear of the power
12. Install the side cover (see "Reinstalling the side cover" on page 44).
13. Connect the external cables and power cords.
If you have other devices to install or remove, do so now; otherwise go to
"Completing the installation" on page 42.
40
System x3200 Types 4362 and 4363: User's Guide
1. Review the safety information that begins on page v and "Installation
guidelines" on page 18.
2. Turn off the server and attached devices; then, disconnect all power cords and
external cables.
3. Remove the side cover (see "Removing the side cover" on page 21).
4. Disconnect the power cord from the power supply that is to be removed.
5. Press down on the orange release lever and pull the power supply out of the
bay, using the handle.
6. If you are instructed to return the hot-swap power supply, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
7. Touch the static-protective package that contains the hot-swap power supply to
any unpainted metal surface on the server; then, remove the power supply
from the package and place it on a static-protective surface.
8. Place the power supply into the bay guides.
9. Press down on the orange release lever and push the power supply toward the
front of the chassis until it locks into place.
power supply and connect the other end of the power cord into a properly
grounded electrical outlet.
supply are lit, indicating that the power supply is operating correctly.