IBM x3200 4362 User Manual page 48

To install a simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all external cables
3. Unlock the side cover (the bezel will not disengage from the server if the cover
4. Remove the side cover and lower bezel (see "Removing the side cover" on
5. Touch the static-protective package that contains the drive to any unpainted
6. Align the drive assembly with the guide rails in the bay (the connector end of
7. Pull the loops of the drive assembly toward each other; then, carefully slide the
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 42.
The simple-swap-drive backplate controls the IDs for the internal simple-swap drive
bays. The following table lists the IDs for the hard disk drives and backplate that
are connected to simple-swap models.
34
System x3200 Types 4362 and 4363: User's Guide
on page 18.
and power cords.
is locked).
page 21 and "Removing the two-piece bezel" on page 22).
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
the drive goes in first).
drive assembly into the drive bay until it stops and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.
Table 2.
Device
Drive bay 4
Drive bay 5
Drive bay 6
Drive bay 7
ID
0
1
2
3