IBM x3200 4362 User Manual page 39

Hide thumbs Also See for x3200 4362:

Table of Contents

The following illustration shows the dual inline memory module (DIMM) connectors

and corresponding LEDs on the system board.

Attention:

Static electricity that is released to internal server components when

the server is powered-on might cause the server to stop, which could result in the

loss of data. To avoid this potential problem, always use an electrostatic-discharge

wrist strap or other grounding system when you work inside the server with the

power on.

To install a DIMM, complete the following steps:

1. Read the safety information that begins on page v and "Installation guidelines"

on page 18.

2. Turn off the server and peripheral devices, and disconnect the power cords and

all external cables.

3. Remove the side cover (see "Removing the side cover" on page 21).

DIMM 1

DIMM 2

DIMM 3

DIMM 4

DIMM 4 error LED

DIMM 3 error LED

DIMM 2 error LED

DIMM 1 error LED

Chapter 2. Installing optional devices

Table of Contents

X3200 4363