IBM x3200 4362 User Manual page 46

To install a hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Unlock the side cover.
3. Remove the side cover and lower bezel (see "Removing the side cover" on
4. Touch the static-protective package that contains the drive to any unpainted
5. Install the hard disk drive in the hot-swap bay:
32
System x3200 Types 4362 and 4363: User's Guide
Drive tray handle
(in open position)
on page 18.
page 21 and "Removing the two-piece bezel" on page 22).
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
a. Make sure that the drive tray handle is open.
b. Align the drive assembly with the guide rails in the bay.
c. Gently slide the drive assembly into the drive bay until the drive stops.
d. Push the drive tray handle to the closed (locked) position.
e. Check the hard disk drive status indicator to make sure that the hard disk
drive is operating correctly. (You might have to restart the server before the
drive is recognized.) If the amber hard disk drive status LED for a drive is lit
continuously, it indicates that the drive is faulty and must be replaced. If the
green hard disk drive activity LED is flashing, this indicates that the drive is
being accessed.
Note: If the server is configured for RAID operation using an optional
ServeRAID adapter, you might have to reconfigure your disk arrays after
installing hard disk drives. See the ServeRAID documentation on the IBM
ServeRAID Support CD for additional information about RAID operation and
complete instructions for using ServeRAID Manager.
Filler panel
Drive-tray
assembly