Connecting Weld Cable; Installing And Threading Welding Wire - Red-D-Arc SuitCase 12VS Owner's Manual

3-6. Connecting Weld Cable

1
3

3-7. Installing And Threading Welding Wire

1
WOOD
OM-224 175 Page 12
From Wire Feeder
2
2
6 in
(150 mm)
Pull and hold wire; cut off end.
Tighten
Clockwise
Rear View
Installing Wire And Adjusting
Hub Tension:
Hold wire tightly to keep it
1
from unraveling.
2
Remove retaining ring, and install
spool so hub pin fits spool hole. Re-
install retaining nut.
Adjust tension knob so only a slight
force is needed to turn spool.
Threading Welding Wire:
3
Lay gun cable out straight.
Open pressure assembly, hold wire
tightly, and cut off end. Push wire
through guides into gun.
Close and tighten pressure assem-
bly. Press jog switch until wire
3
comes out gun.
Feed wire against wooden surface,
and tighten knob so wire does not
slip.
Cut off wire, and close door.
Y Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
1 User-Suppled Weld Cable
Follow wire manufacturer's recom-
mendations for weld cable polarity.
2 User-Suppled Male Connector
3 User-Suppled Female
Connector
Push female connector over male
connector, and turn 1/4 turn clock-
wise.
804 004-A
Retaining Nut
Hub Tension Adjustment Knob
Pressure Assembly
Adjustment Knob
Ref. 804 005-A