Installing The Rear Rail - Craftsman 315.228310 Owner's Manual

INSTALLING THE REAR RAIL

See Figures 12 – 14.
WARNING:
Front and rear rails must be
installed and carefully aligned to reduce the risk
of kickback. Kickback can result in serious injury.
From the carton, remove the rear rail and the
following hardware:
6 square head bolts (5/16-18 x 1 in.)
6 flat washers (5/16 in.)
6 hex nuts (5/16-18)
Right and left end caps for rear rail
2 screws (5/32-32 x 1/2 in.)
Note: Remaining hardware from this hardware bag is
used for installing the front rail and end caps.
At the back of the table, put the square head bolts
in the holes in the edge of the table and extensions
so the bolt heads extend outward 1/2 in.
Under the table, loosely attach washers and hex
nuts onto bolts. Slide the slot on the rear rail over
the bolts. Adjust each bolt to fit the rail closely to
the table.
Position rail so that right hand edge extends 2-1/2
inches beyond table extension.
Push the rail against table and tighten each nut with
a 12 mm wrench. If the rail jams and does not slide
easily over the bolts, re-align the table extensions.
Put the end caps on the rail ends. Insert the screws
and tighten with a phillips head screwdriver.
SLOT
REAR RAIL
SQUARE
HEAD BOLTS
ASSEMBLY
TABLE
EXTENSION
HEX NUT
FLAT
WASHER
Fig. 12
21
SQUARE
HEAD BOLTS
TABLE
EXTENSION
REAR RAIL
REAR OF SAW
HEX NUT
FLAT
WASHER
TABLE
REAR RAIL
Fig. 13
2-1/2 in.
END CAP
SCREW
Fig. 14
® TABLE SAW 315.228310