Introduction; General - BBV Rx10X Installation Manual

2. INTRODUCTION

GENERAL

The Rx10X telemetry interface is designed to allow control of a variety of integrated dome cameras
using BBV's range of up-the-coax telemetry transmitters.
Rx10X TECHNICAL SPECIFICATION
Power Requirements:
Current Consumption:
Features:
Engineering Facilities:
Rx10X installation manual V3.02
Rx10X
12 – 36Vdc
24Vac from the dome supply(excluding the Dennard dome)
This unit is supplied with a 2.1mm Jack power fly lead. In addition a
PSU3 (12V 1A in line PSU) can be ordered from BBV
Rx10X/AL
12 – 24Vac or dc
24Vac from the dome supply (excluding the Dennard dome)
Rx10X/WBX
12 – 24V ac or dc
24Vac from the dome supply (excluding the Dennard dome)
Rx10X/24/WBX
230Vac Powered
24Vac 3A Output to power the dome and receiver (excluding the Dennard dome)
100mA maximum @ 12Vdc
Rx10X
 Two PCB construction.
 Serial data output 2 wire RS232/422/485
 Up to 16 preset positions can be stored using the Rx10X, depending
on the protocol, please read ahead for full details.
Rx10X/AL
 Single PCB construction
 Supports 4 local alarm inputs with 1 outputs
 Up to 16 preset positions can be stored using the Rx10X, depending
on the protocol, please read ahead for full details.
Rx10X/WBX
 Includes all the features of the Rx10X/AL
 Additional relay capable of switching up to 1kW loads.
 Supplied in an IP67 enclosure for external applications.
Rx10X/24/WBX
 Includes all the features of the Rx10X/AL and Rx10X/WBX
 24Vac 3A output to power both the dome and the receiver.
 Unit auto-tunes to the coaxial telemetry signal
 7 Segment LED readout for continual system status
 Data out LED
 Video launch amplifier provided with Gain and Lift controls
Page 6