Panasonic Wv-Cvs 850 & Wv-Cvs 960 - BBV Rx10X Installation Manual

Protocol 10
Panasonic WV-CVS 850 & WV-CVS 960
Variable speed Pan/Tilt.
Zoom/Focus, Auto focus, Iris Open/Close (Hold for auto-iris)
16 full scene presets
2 preset patrols
Autopan/Patrol learn-play using autopan key
Vista up the coax Option 5
Panasonic WV-CS850 / 860 / 960
ENTRY/EXIT dome menu
SET (select menu item)
ESC (back to previous menu)
SPECIAL2 (for special menus)
The dome's internal PATROL can be LEARNED using the dome menu. Setting the AUTO PAN KEY to PATROL will allow the
patrol to be PLAYED by pressing AUTOPAN on the controller.
RS485 control of dome using the following connections:
Description
Dome Connection
Green DATA +
Yellow
DATA
Options Functions
Option 1 Enable datum mode goto preset 1 after 5 minutes if inactivity.
Option 3 A dome RESET ALL command can be sent by selecting option 3 and sending 4 '#' twice within 5 seconds. This can
only be done when not within the menu.
Care must be used with this command as the dome is set to default and user settings are erased.
Option 5 Vista receive mode
Dome Switch settings:
The following procedure must be followed to ensure that the dome is set-up correctly for terminated 4 wire RS485 at 19200 Baud
and address 1. Remove the dome from its base before each step and reconnect to the base after changing the switches.
Step 1: Address switches 2, 4 and 5 ON
Step 2: Address switches 1, 3, 4 and 5 ON
Step 3: Address switches 1 and 8 ON. 4 Way switch 1 ON to select 4 wire, terminated RS485.
Rx10X installation manual V3.02
Tx40X
'#' 1
'#' 2
'#' 3
'#' 4
Rx10X
J6/5
-
J6/4
J6/3
Gnd
J6/2
J6/1
Tx1000 Tx1500
1 '#'
'#' WASH
2 '#'
'#' WIPE
3 '#'
'#' AUTOPAN
4 '#'
'#' LIGHTS
VistaMUX
Goto Preset 25
Goto Preset 26
Goto Preset 27
Goto Preset 28
Page 24