Jvc Tk-C655B, 675B, Tk-C675E, Tk-C675Be & 676 - BBV Rx10X Installation Manual

Protocol 11
JVC TK-C655B, 675B, TK-C675E,
TK-C675BE & 676
Variable speed Pan/Tilt.
Zoom/Focus, Auto focus can be enabled/ disabled from the dome menu.
16 Full scene presets.
2 preset patrols.
Slow patrol or dome autopan from controller AUTOPAN key
Vista up the coax Option 5
TK-C676
OPEN MENU and BACK (Twice)
SET
Toggle ExDR
Cycle Mono Mode
TK-C675B Option 4
SHUTTER SPEED
BACKLIGHT AREAS
AGC 0,12,20dB
DOME RESET
A dome reset sets the camera as follows:-
Shutter to 1/50 sec, Backlight comp. off AGC to 20dB
The dome will display any change of Shutter Speed, Backlight or AGC for a short period.
RS485 control of dome using the following connections:
Description
Dome Connection
C (Rx +)
D (Rx - )
Notes:
Camera switch settings:
MACHINE ID – set both rotary switches to '0'
8 way DIL switch, all OFF apart from 8 which should be ON to enable the RS485 termination, point-to-point, simplex.
On screen display of preset position, P01 - P16 or MANUAL during manual control. The on screen display can be enabled/disabled using dome
switch SW3, ON = Display off, OFF = Display on.
Options Function
Option 1: Enable datum mode goto preset 1 after 5 minutes if inactivity.
Option 2: Will perform a slow patrol between programmed presets when AUTOPAN pressed.
Option 3: on to allow the ExDR and MONO mode status to be displayed. Have this off if you are programming a dome camera title and do not
want to display the ExDR and MONO status.
Option 4: TK-C675B mode.
Option 5: Vista receive mode
DOME MENU
Pressing #1 twice will display the dome's menu. The joystick is then used to navigate through the dome menu. #2 sends a SET command to the
dome and #1 twice whilst the menu is displayed sends a BACK command.
If the #1 command doesn't work press a focus key before sending #1.
Pressing #1 FOUR times within 2 seconds will display the dome's service menu.
Rx10X installation manual V3.02
Tx40X
'#' 1
'#' 2
'#' 3
'#' 4
TX40X
'#' 1
'#' 2
'#' 3
'#' 4
Rx10X
DATA + J6/5
-
J6/4
DATA
Gnd J6/3
J6/2
J6/1
Tx1500
Tx1000
1 '#'
'#' WASH
2 '#'
'#' WIPE
3 '#'
'#' AUTOPAN
4 '#'
'#' LIGHTS
Tx1000 Tx1500
1 '#'
'#' WASH
2 '#'
'#' WIPE
3 '#'
'#' AUTOPAN
4 '#'
'#' LIGHTS
Vista Mux
Goto Preset 25 (x2)
Goto Preset 26
Goto Preset 27
Goto Preset 28
Vista Mux
Goto Preset 25 (x2)
Goto Preset 26
Goto Preset 27
Goto Preset 28
Page 21