Table of Contents
Advertisement
6.DOME SPECIFIC INFORMATION
Protocol 08
Dennard 2040, 2050, 2055 & 2060 dome.
The Rx10X can not be powered from the same
supply as the Dennard dome.
Variable speed Pan/Tilt.
Zoom/Focus, Auto focus
16 full scene presets (additional presets can be programmed using dome's menu)
2 preset patrols
Dennard 2040, 2050, 2055 & 2060
Dome User Menu
Dome Supervisor Menu
Dome Service Menu
The domes internal Sequence 001 can be started by pressing AUTOPAN. The sequence must be programmed
from the dome supervisor menu.
RS485 control of dome using the following connections:
Dome Connection
7 Pin Plug
RS485
BS Yellow
Pin 4
BS Green
Pin 3
Gnd
The Dome must be addressed as 1 this is achieved by setting
Notes:
Accessing the dome menus:
Press relevant key combination to display menu. To select highlighted menu item, perform a Goto preset 1 function as follows:
-Tx1500 press 1 followed be the preset key, Tx1000 Hold the PRESET key and tap the CAM1 key, Tx40X press the PRESET1
key.
The cursor can be moved using the standard pan/tilt keys or joystick. If the cursor direction is reversed, the pan and tilt cursor
directions can be reversed from the SUPERVISOR, USER OPTIONS, CURSOR CONTROL REVERSE menu.
Presets positions greater than 17 can be programmed using the dome's menu and can be built into dome sequences. Please
refer to dome manual for specific instructions regarding programming of sequences.
Options Function
Option 1 Enable datum mode goto preset 1 after 5 minutes if inactivity
Rx10X installation manual V3.02
Description
Rx10X
DATA +
J6/5
-
J6/4
DATA
Gnd
J6/3
J6/2
J6/1
Tx40X
Tx1000
'#' 1
'#' WASH
'#' 2
'#' WIPE
'#' 3
'#' AUTOPAN
BLUE
0
YELLOW
rotary sw. to
&
Tx1500
1 '#'
2 '#'
3 '#'
1
rotary sw. to
Page 18
Hide quick links:
Advertisement
Table of Contents
