Philips Auto Dome (Rs232/485) - BBV Rx10X Installation Manual

Protocol 13
Philips AutoDome including G3A and G3B
(RS232/RS485 control only, not Bi-Phase compatible)
Variable speed Pan/Tilt..
Zoom/Focus, Auto focus.
16 full scene presets.
2 preset patrols.
Dome AutoPlay record & playback.
Preshot title,
Zone title,
Menu Access
Philips protocol
Display Menu
Program Zone Title
Record AutoPlay start/stop
RESET DOME!
RS232 & RS485 control of dome. Data rate, 9600 Baud, No parity, 8 Data bits, 1 Stop bits
RS485 control of dome using the following connections:
Dome Connection
RS232
RS485
Not Used RxD
RxD
TxD
Gnd
Options Function
Option 1 - Enable datum mode goto preset 1 after 5 minutes if inactivity.
Option 2 – Dome address, off = address 1, on = address 10,000 (special so all domes will respond)
Option 3 – Preset text title programming
OFF – preset title text is programmed following a save preset command by automatically issuing an aux (62) command.
ON – the preset text command is not sent and the existing text is retained.
Option 4 – special option for SWT providing Fixed speed pan/tilt (Added in V11 software)
The dome must be RS232 controllable. BI-PHASE domes cannot be controlled.
Dome settings: Select dome address #0 or #1. Communications must be 9600, N, 8, 1. The G3 Basic address is software
programmable; however as default the dome is addressed as #0. If the dome address is not #0 or #1 then the dome will require
reprogramming using a Philips controller or turn on option 2.
Rx10X installation manual V3.02
Tx40X
(Aux 46)
(Aux 63)
(Aux 100)
(Set 899)
Description Rx10X
DATA + J6/5
-
J6/4
DATA
Gnd J6/3
J6/2
J6/1
Tx1000
'#' 1 '#' WASH
'#' 2 '#' WIPE
'#' 3 '#' AUTOPAN
'#' 4 '#' LIGHTS
Tx1500
1 '#'
2 '#'
3 '#'
4 '#'
Page 27