Related Manuals for Elumen8 Stage Par 220
Summary of Contents for Elumen8 Stage Par 220
- Page 1 Stage Par 220 Order Code: ELUM006 User Manual Innovation, Quality, Performance Please read the instructions carefully before use...
- Page 2 7. Troubleshooting Following are a few common problems that may occur during operation. Here are some suggestions for easy troubleshooting: A. The fixture does not work, no light 1. Check the connection of power and main fuse. TABLE OF CONTENTS 2.
-
Page 3: Dmx512 Connections
6. DMX512 Connections 1. Safety Introductions The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels. Please read the instructions carefully which includes important information about the installation, operation and maintenance. WARNING Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. -
Page 4: Dmx512 Configuration
Do not allow children to operate the fixture. 5. DMX512 Configuration Do not touch any wire during operation as there might be a hazard of electric shock. Avoid power wires together around other cables. Mode 4&5； Disconnect mains power before fuse/lamp replacement or servicing. Replace fuse only with the same type. - Page 5 4. How To Control The Unit 2. Technical Specifications You can operate the unit in three ways: 1. By master/slave built-in preprogram function Voltage:100-240V~ 50/60Hz 2. By DMX controller LED: 10W RGBW LED x 22pcs There is no need to turn the unit off when you change the DMX address, as new DMX Fuse: T 6.3A Power consumption:283W address setting will be effected at once.
- Page 6 ○ change press the MENU button. 2 LED: DMX input present Manual setting color MASTER Master Mode Press the MENU button up to when is shown on the display. Pressing the ENTER SLAVE Slave Mode or … or button, and use the DOWN and UP buttons to select SOUND Flashing Sound activation...
- Page 7 Sensitivity Press the MENU button up to when is shown on the display. Pressing the ENTER button and the display will blink. Use DOWN and UP buttons to adjust sensitivity of the sound control from 0 to 100. Once selected, press the ENTER button to setup or automatically exit menu mode without any change after one minute.
- Page 8 DMX 512 Address Setting Dimmer Mode Press the MENU button up to when is showing on the display. Pressing the ENTER Press the MENU button up to when is shown on the display. Pressing the ENTER button and the display will blink. Use the DOWN and UP buttons to change the DMX 512 button and the display will blink.