Overview: You should find inside the Elemen8 carton the following items: 1, LED Zoom 2, Instruction manual, 3, Power Cable Technical Specifications: DMX channels: 1 or 3 selectable 1 x 50W or 100W White LED (5600K or 3200K) Dimming, master/slave and DMX modes 400Hz refresh rate 5-pin XLR in/out sockets 4 push button menu with LCD display...
Operation: 1, Dimming Mode To enter the dimming mode, press the “MODE” button to show “DIMMER” on the LCD display. Now press the “ENTER” button and use the “UP” and “DOWN” buttons to set the brightness from 00-99. Now press the “ENTER” button again to add strobe and use the “UP” and “DOWN” buttons to change the flash speed from 00-99.
Page 6
DMX Charts 3 channel mode: Channel Value Function 0-255 Dimming 0-100% 0-255 Strobe speed (slow to fast) 0-15 Dimmer curve and response select on fixture 16-45 Dimmer curve Linear response halogen 46-75 Dimmer curve Square response halogen 76-105 Dimmer curve Inverse Square response halogen 106-135 Dimmer curve S response halogen 136-165...
Page 7
Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing. Grounding the shield could cause a short circuit and erratic behaviour.