Advertisement
○
2 LED:
DMX
On
MASTER
On
SLAVE
On
SOUND
Flashing
○
3 Button:
MENU
To select the programming functions
DOWN
To go backward in the selected functions
UP
To go forward in the selected functions
ENTER
To confirm the selected functions
○
4 Microphone: Receive music for the sound active.
○
5 DMX output: For DMX512 link, use 3/5-pin XLR plug cable to link the next unit.
○
6 DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal
○
7 Mains input: Connect to supply mains power for the next unit.
3.2 Main Function
To select any functions, press the MENU button until the required one is shown on the
display. Select the function pressing the ENTER button and the display will blink. Use the
DOWN and UP button to change the mode. Once the required mode has been selected,
press the ENTER button to setup or it will automatically return to the main functions without
any change after idling one minute. Back to the functions without any change press the
MENU button. The main functions are shown below:
DMX input present
Master Mode
Slave Mode
Sound activation
5-
change press the MENU button.
Manual setting color
Press the MENU button up to when
button, and use the DOWN and UP buttons to select
(strobe), press the ENTER button to confirm and use the DOWN and UP buttons to adjust
the value between 0 and 255, once selected, press the ENTER button to setup or
automatically exit menu mode without any change after one minute. To go back to the last
function without any change press the MENU button.
Self-Test
Press the MENU button up to when the
ENTER button and the unit will run the built-in programmer for self-test. To go back to the
functions press the MENU button.
Temperature Test
Press the MENU button up to when
button and the display will show the temperature of the unit. To go back to the functions
press the MENU button again.
Fixture Hours
Press the MENU button up to when
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button.
Software version
Press the MENU button up to when
button and the display will show the version of software of the unit. To go back to the
functions press the MENU button again.
is shown on the display. Pressing the ENTER
or ... or
,
is blinking on the display. Pressing the
is blinking on the display. Pressing the ENTER
is blinking on the display. Pressing the ENTER
is blinking on the display. Pressing the ENTER
10-
Advertisement
