Recording On A Tape - Panasonic Palmcorder PV-GS320 Operating Instructions Manual

Recording on a tape

Remove the lens cap. (
(When the Camcorder is turned on with the
lens cap attached, the automatic white
balance adjustment may not function
properly. Please turn the Camcorder on after
removing the lens cap.)
When this unit is purchased, the aspect ratio is
set to [16:9] for recording images compatible with
a wide-screen TV. To make this unit compatible
with regular TVs (4:3), change the [ASPECT]
setting before recording the images (
change the [TV ASPECT] setting when watching
them on the connected TV (
≥ Set to Tape Recording Mode.
1
Press the recording start/stop button to
start recording.
2
Press the recording start/stop button again
to pause recording.
≥For the recording time on a tape, refer to
≥Carry out a recording check (
the image is recorded properly.
≥In order to find the unrecorded section, carry out
the blank search (
-30-
≥If you want to preserve the original sound
recorded when audio dubbing (
[ADVANCED] >> [AUDIO REC] >> [12bit] to
take pictures.
)
-14-
) or
-37-
).
-44-
;
-16-
) to verify that
-30-
) .
), set
-49-
Record mode
ª On-screen display in the tape
recording mode
¢These are only displayed when you press the
Photoshot button [
inserted. These are not displayed when using
the remote control.
1) Recording time elapse
2) Remaining tape indication
3) Still picture size
4) Card indication (
5) Number of recordable still pictures
(When no picture can be recorded, this
indication will flash in red.)
6) Quality of still pictures
ª Concerning the remaining tape time
indication on the screen
≥The remaining tape time is indicated in minutes.
(When it reaches less than 3 minutes, the
indication starts flashing.)
≥During a 15-second or shorter recording, the
remaining tape time indication may not be
displayed or the remaining tape time may not be
displayed correctly.
≥In some cases, the remaining tape time
indication may display remaining tape time that
is 2 to 3 minutes shorter than the actual
remaining tape time.
ª [POWER SAVE]
[OFF]:
.
[5 MINUTES]: When 5 minutes passes without
≥In the following cases, the power may not turn
off even when [POWER SAVE] >>
[5 MINUTES] is set.
≥When connected to the AC outlet
(When using the AC adaptor)
0h00m10s00f 0h00m10s00f
R 0:30 R 0:30
100 100 1
] halfway while a card is
)
-66-
When 5 minutes passes without
any operation, the standby mode
will be automatically set. In the
standby mode, [;] blinks and it
takes more time than usual to start
recording after you press the
recording start/stop button.
any operation, the Camcorder
automatically turns off to protect
the tape or to prevent the battery
from running down. When you
want to use the Camcorder, turn it
on again.
1)
2)
3)¢
4)¢
5)¢
6)¢
29
LSQT1091