Inserting/Removing A Cassette; Inserting/Removing A Card; Lsqt1091 - Panasonic Palmcorder PV-GS320 Operating Instructions Manual

Inserting/removing a cassette

1
Fit the AC adaptor or the battery and turn on
the power.
2
Slide the [OPEN/EJECT] lever and open the
cassette cover.
≥When the cover is fully opened, the cassette
holder will come out.
3
After the cassette holder is opened, insert/
remove the cassette.
≥When inserting a cassette, orient it as shown
in the figure and then securely insert it as far
as it goes.
≥When removing, pull it straight out.
4
Push the [PUSH] mark 1 in order to close
the cassette holder.
≥The cassette holder is housed.
5
Only after the cassette holder is completely
housed, close the cassette cover tightly.
≥When inserting a previously recorded cassette,
use the blank search function to find the position
where you want to continue recording. If you are
overwriting a previously recorded cassette, be
sure to find the position where you want to
continue recording.
≥When closing the cassette cover, do not get
anything, such as a cable, caught in the cover.
≥After use, be sure to rewind the cassette
completely, remove it and put it in a case. Store
the case in an upright position. (
≥If the indicator of the condensation does not
display on the LCD screen and/or EVF and you
notice condensation on the lens or the main
unit, do not open the cassette cover otherwise
20

LSQT1091

Before using
condensation may be formed on the heads or
the cassette tape. (
ª
≥Close the cassette cover completely and then
open it again completely.
≥Check if the battery has run down.
OPEN/
EJECT
ª
≥Set the [OFF/ON] switch to [OFF], then to [ON]
again.
≥Check if the battery has run down.
ª
If the accidental erasure prevention slider 1 of a
cassette is opened (slide in the direction of the
[SAVE] arrow), the cassette cannot be recorded.
When recording, close the accidental erasure
prevention slider of the cassette (slide in the
direction of the [REC] arrow).

Inserting/removing a card

Before inserting/removing a card, set the [OFF/
ON] switch to [OFF].
≥If the card is inserted or removed with the power
turned on, this Camcorder may malfunction or
the data recorded on the card may be lost.
1
1
PUSH
2
)
-74-
-72-
When the cassette holder does not
come out
When the cassette holder cannot be
housed
Accidental erasure prevention
1
R E C
SAVE
Turn off the power 1 .
≥Check that the Status indicator has gone off.
Open the card slot cover.
)
1