Elumen8 ELUM121 User Manual page 9

DMX Settings
To select DMX Settings, press the ENTER button to confirm, use the UP/DOWN buttons to select
DMX Address or Channel Mode
DMX Address
To select DMX Address, press the ENTER button to confirm. Use the UP/DOWN buttons to
adjust the address from 1 to 512, press the ENTER button to setup. To go back to the
functions without any changes press the MENU button again. Press and hold the MENU
button for about one second or wait for one minute to exit the menu mode.
Channel Mode
To select Channel Mode, press the ENTER button to confirm. Use the UP/DOWN buttons to
select Mode 1 (4 ch) or Mode 2 (9 ch) To go back to the functions without any changes press
the MENU button again. Press and hold the MENU button for about one second or wait for
one minute to exit the menu mode.
Stand Alone
To select Stand Alone, press the ENTER button to confirm, use the UP/DOWN buttons to select
Colour Dimming Mode, Static Colour Mode or Colour Macro.
Colour Dimming Mode
To select Colour Dimming Mode, press the ENTER button to confirm. When you select Mode
1 (4 ch), use the UP/DOWN buttons to select Red, Green, Blue or White. If you choose Mode
2 (9 ch),use the UP/DOWN buttons to select Red, Green, Blue, White, Lee compatible colour,
Colour-Temp, Strobe, Dimmer or Dimmer fine mode, press enter, use the UP/DOWN button
to select desired value 000-255, press ENTER button to save, when using this mode please
make sure Strobe is set to value 255, do not press MENU as this action will exit the
stand-alone mode, press ENTER to save. The fixture will remember the stand-alone mode set
even after a power off and back on cycle.
8