Elumen8 ELUM121 User Manual page 12

Fixture Test
To select Fixture Test press the ENTER button to confirm, use the UP/DOWN button to select the
Auto Test Mode, press the ENTER button to run the built-in test routine. To go back to the
functions without any changes press the MENU button again. Press and hold the MENU button for
about one second or wait for one minute to exit the menu mode.
Fixture Information
Enter menu mode, select Fixture Information, press the ENTER button to confirm, use the
UP/DOWN button to select the Fixture Use Time, LED Temp. or Firmware Version.
Fixture Use Time
To select Fixture Use Time, press the ENTER button to confirm, and the total number of
fixture hours will show on the display. To go back to the functions without any changes press
the MENU button again. Press and hold the MENU button for about one second or wait for
one minute to exit the menu mode.
LED Temp.
To select LED Temp., press the ENTER button to confirm, the current running temperature of
the fixture will show on the display. To go back to the functions without any changes press
the MENU button again. Press and hold the MENU button for about one second or wait for
one minute to exit the menu mode.
Firmware Version
To select Firmware Version, press the ENTER button to confirm, the software version will
show on the display. To go back to the functions without any changes press the MENU button
again. Press and hold the MENU button for about one second or wait for one minute to exit
the menu mode.
11