Elumen8 ELUM121 User Manual page 10

Static Colour Mode
To select Static Colour Mode, press the ENTER button to confirm. Use the UP/DOWN button
to select Color 1~Color 32 mode, do not press MENU as this action will exit stand-alone mode
selected, press ENTER to save. The fixture will remember the stand-alone mode set even after
a power off and back on cycle.
Colour Macro Mode
To select Colour Macro, press the ENTER button to confirm. Use the UP/DOWN button to
select Macro 1~Macro 7 mode, the seven Macro's are all a colour scrolling fade with macro 1
the fastest and macro 7 the slowest, do not press MENU as this action will exit stand-alone
mode selected, press ENTER to save. The fixture will remember the stand-alone mode set
even after a power off and back on cycle.
Dimmer Curve
To select Dimmer Curve, press the ENTER button to show the DIMMER CURVE on the display, the
current setting will be highlighted on the display, use the UP/DOWN button to select Linear,
Square Law ,Inverse Square Law or S cure. To go back to the functions without any changes press
the MENU button again. Press and hold the MENU button for about one second or wait for one
minute to exit the menu mode.
Square Law: Light intensity control is finer at low levels and coarser at high levels.
Inverse Square Law: Light intensity control is coarser at low levels and finer at high levels.
Linear: The increase in light intensity appears to be linear as DMX value is increased.
S-curve: Light intensity control is finer at low and high levels and coarser at medium levels.
9