Product Specifications - Hitachi C 10FL Instruction Manual And Safety Instructions

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals
known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals, work in a well-ventilated area and work with approved safety equipment such as dust masks that are
specially designed to filter out microscopic particles.

PRODUCT SPECIFICATIONS

MOTOR
HP (Maximum developed) ............ 3.0
Type ................................................ Induction
Amps .............................................. 15 / 7.5
Voltage ........................................... 120 / 240
Hz .................................................... 60
RPM (no load) ................................ 3450
Overload Protection ...................... YES
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 110-120/220-240 Volt operation. It must be connected to a 110-120 Volt / 15
Ampere or 220-240 Volt / 7.5 Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord
immediately if it is worn, cut or damaged in any way.
Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow these rules
could result in serious injury to you or damage to the table saw.
WARNING
SAW
Table Size ....................................... 27-1/8" x 20-1/8"
Table Extensions ........................... Left & Right
Extension Fence Capacity ............. 24" Left & Right
Blade Size ....................................... 10"
Rip Scale ........................................ YES
Rip Fence ........................................ YES
Miter Gauge ................................... YES
Maximum Cut Depth @ 90° .......... 3-3/8"
Maximum Cut Depth @ 45° .......... 2-1/4"
Maximum Dado Cut Width ........... 13/16"
Net Weight ..................................... 264.5 LBS
WARNING
— 3 —
English