Panasonic U-4LE1E5 Service Manual page 69

1. Simple Settings Function 1. Simple Settings Function
When the operating mode at the priority remote controller is changed, the operating modes of other remote
controllers change as shown below.
Mode change at priority remote controller Operating modes at other remote controllers
Current mode
Cooling or dry
Heating
Cooling
Heating
Cooling or dry
Heating
Item code
Fan speed setting when
05
heating thermostat is OFF
Heating intake temperature
06
shift
07 Electric heater installation
Humidifying when heater
08
thermostat is OFF
Permit/prohibit automatic
0D
heating/cooling
0F
Cooling-only
New mode Current mode
Cooling or dry
Heating
Fan
Heating
Cooling
Fan
Cooling
Dry
Dry
Heating
Dry
Fan
Cooling
Fan Dry
Fan
Heating
Fan
Fan
Item
Changes the fan speed setting when the heating thermostat is OFF.
Shifts the intake temperature during heating.
Can be set when the body thermostat is used.
Set when cost distribution is performed using an AMY central control system
or similar system, and when an optional electric heater is installed.
(This is unrelated to control of the electric heater.)
Normally humidifying does not occur when the thermostat is OFF during
heating operation. However, this setting can be changed in order to increase
the amount of humidifying.
Caution: In order to avoid water leakage and damage to the fan, do not use
this setting unless a vaporizing humidifier is used.
This setting can be used to prevent the automatic heating/cooling display on
the remote control if the unit configuration permits automatic heating/cooling
operation.
This setting allows a heat pump indoor unit to be operated as a cooling-only
unit.
New mode
Heating
Fan (not changed)
Cooling
Fan (not changed)
Cooling (not changed)
Dry (not changed)
Cooling
Fan (not changed)
Cooling (not changed)
Dry (not changed)
Fan (not changed)
Heating (not changed)
Fan (not changed)
Description
4 - 7
Mini VRF SYSTEM Mini VRF SYSTEM
Remote Controller Functions Remote Controller Functions
4