Sensor Angle Adjustment; Override; Ceiling Mount; Wall Mount - wattstopper DT-200 Installation Instructions Manual

Sensor Angle Adjustment

While watching the LEDs for fl ashes (Red LED indicates activation from the
PIR sensor; Green LED indicates activation from the ultrasonic sensor), have
a person walk back and forth at the far end of the space. Increase or decrease
mounting angle as needed until the desired coverage is achieved.
Tighten the Tightening Screw to hold this position.

Ceiling Mount

PARALLEL
to VERTICAL
at 10 foot
mounting
height
Reference Surface
Angle

Override

To override all sensor functions, set the Ultrasonic Sensitivity trimpot to the fully
counterclockwise (Override) position. This bypasses the occupancy control functions
of the sensor, but still allows the lights to be manually controlled with a light switch,
if one is installed.
Visit our website for FAQs: www.wattstopper.com

Wall Mount

PARALLEL
fi g. C
to WALL
at 10 foot
mounting
height
Reference Surface
Angle