Controls & Components - Grizzly G0453W Owner's Manual

Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to Figures 1–3 and the following descrip-
tions to become familiar with the basic controls
and components of this machine. Understanding
these items and how they work will help you
understand the rest of the manual and stay safe
when operating this machine.
A
G0453W
E
F
G0454ZW
Figure 1. Table elevation and feed controls.
A. Magnetic ON/OFF Switch: Green start but-
ton turns motor ON when pressed. Red
Emergency Stop button turns motor OFF
when pressed; for safety purposes, this button
will remain depressed and prevent restarting
until reset. Reset by rotating clockwise until it
pops out.
B. Table Height Handwheel: Raises and low-
ers table to accommodate different workpiece
thicknesses. One complete revolution moves
the table approximately
-4-
manual BEFORE
B
C
D
⁄ ".
1
16
C. Feed Rate Control Knob: Selects 20 FPM
feed rate when pushed in and 16 FPM feed
rate when pulled out.
D. Table Locks:
position when tightened.
E. Control Panel for Magnetic Switch: Green
START button turns motor ON when pressed.
Red Emergency STOP button turns motor
OFF when pressed; for safety purposes, this
button will remain depressed and prevent
restarting until reset. Reset by rotating clock-
wise until it pops out.
F. Depth Limiter: Limits depth of cut to a maxi-
mum of ⁄ " at full width.
1
8
G
Figure 2. Return rollers and dust port.
G. Return Rollers: Assist sliding workpiece
back to operator following planing operation.
H. Dust Port: Connects to a dust collection
system to extract shavings and dust during
operation.
I
Figure 3. Mobile-base foot pedal.
I. Mobile-Base Foot Pedal: When engaged,
lifts machine onto casters for repositioning.
When disengaged, allows machine to rest
firmly on floor during operations.
G0453W/ZW–G0454W/ZW (Mfd. Since 05/16)
Secure table height
H