Assembly - Grizzly G0453W Owner's Manual

Assembly

To assemble planer:
1. G0453W & G0453ZW: Attach each table
extension wing to planer table with (2) pre-
installed M8-1.25 x 25 cap screws, 8mm lock
washers, and 8mm flat washers,. Do not fully
tighten cap screws at this time.
G0454W & G0454ZW: Attach each table
extension wing to planer table with (4) pre-
installed M10-1.5 x 25 cap screws, 10mm
lock washers, and 10mm flat washers (see
Figure 15). Do not fully tighten cap screws at
this time.
Adjustment
Cap Screws
Figure 15. Front extension wing installed
(Model G0454ZW shown).
2. Using a straightedge as a guide, and table
adjustment set screws and cap screws for
leveling control, position extension wings
even with table and fully tighten cap screws
from Step 1.
Note: Be aware that bed rollers will give you
a false reading with your straightedge if they
are raised above table. Move them down or
work around them when leveling extension
wings (refer to Bed Roller Height on Page
26 for more information).
-18-
3.
Adjustment
Set Screws
(1 of 2)
4.
5.
6.
G0453W & G0453ZW Only: Remove one
pre-installed hex nut from each table locking
rod, then install table lock star knobs on lock-
ing rods (see Figure 16).
Note: Pre-installed hex nuts on table locking
rods are for shipping purposes only and may
be discarded after removal.
Table Lock
Star Knobs
Figure 16. Table lock star knobs installed.
Thread handwheel handle into handwheel
(see Figure 17).
Thread feed rate knob onto feed rate shaft
(see Figure 17).
Secure handwheel on shaft with pre-installed
M5-.8 x 16 cap screw and 5mm flat washer
(see Figure 17).
Handwheel
Handle
Figure 17. Handwheel and T-knob installed.
G0453W/ZW–G0454W/ZW (Mfd. Since 05/16)
Feed Rate
Knob